RTHD螺杆式冷水机组操作简介.ppt

1、指示器用于与CH530面板上显示的EXV位置进行对比； 2、用于EXV机械故障的排查。 蒸发器内的全新设计的分配器本身就能处理气液两相的冷媒混合物，因此取消了气液分离器，减少了费用。 Function: Distribute a mixture of refrigerant gas and liquid such that liquid refrigerant leaves the distributor uniformly over the area above a heat exchanger tube bundle. Distributor is a CRITICAL chiller component: Heat transfer performance and therefore chiller efficiency is directly dependent on successful operation of the distributor. Leaks in distributor have potential to introduce liquid refrigerant carryover into the compressor - Limits operating range of chiller - Compressor reliability / Carry over The distributor is “non-replaceable” once assembled in evaporator - If it doesn’t work – evaporator is scrap Oil that collects in the oil sump is at condensing pressure during compressor operation and is, therefore, constantly moving to lower pressure areas of the chiller. In this system, oil flows in 2 distinct paths, each performing a separate function: 1) bearing lubrication and cooling and 2) rotor oil injection. Oil leaves the sump and passes through an oil filter and master solenoid valve. The master solenoid valve is used to isolate the sump from the low-pressure side of the system when the compressor is shut down, preventing oil migration. The first path is for lubricating and cooling the compressor bearings à. Oil is routed to the bearings located in the rotor and bearing housing. Each housing is vented to the suction side of the compressor so that oil leaving the bearings is routed through the rotors, to the oil separator, and then back to the oil sump. The second path is for lubricating and sealing the compressor rotors á. Oil is injected along the bottom or top of the compressor rotors inside the housing. Its main purpose is to seal the rotor-to-rotor and rotor-to-housing clearances. This seal provides a barrier between the high- and low-pressure cavities of the compressor. Additionally, oil lubricates the male-to-female rotor drive arrangement. -