全回转式过桥船厂动作试验大纲.docVIP

. PAGE .页脚 全回转式过桥装置 Telescopic Gangway 船厂动作试验大纲 Shipyard Operation Test Outline 江阴黄山船舶配件有限公司 JIANGYIN HUANG SHAN MARINE FITTING CO.,LTD 2009.12 目录 INDEX 1.概述 General Description 2.伸缩系统的功能测试 Functional Test of Telescopic System 3.起升系统的功能测试 Functional Test of Lifting System 4.回转系统的功能和操作测试 Function and Performance Test of Slewing System 5.应急起升系统的测试 Emergency Lift Off System 6.报警功能和操作测试 Functional and Performance Test of Alarms 7.操控室和泵站的设备测试 Test of Equipment in Control Cabin and Pump House 8.电力系统的测试 Test of Electrical System 9.着落支座的测试 Landing Cone Test 1.0 概述 General 本大纲规定了新造过桥装置在船厂安装后递交之前需做的动作试验步骤，主要内容如下： This test procedure describes the final acceptance test to be carried out after installation on board. 2.0 伸缩系统的功能 Functional of Telescopic System 2.1 过桥在水平位置能完全伸展和缩回；The telescopic bridge is to be totally extended and retracted in horizontal position. 功能正常，签字,日期 Test OK. Signature and date 2.2 过桥在起升位置能完全伸展和缩回（必须是最大位置），此时支持起升的截止阀工作正常； The telescopic bridge is to be totally extended and retracted in lifted position. (Max. lifted position available) The function of the blocking valves is to work satisfactory. 功能正常，签字,日期 Test OK. Signature and date 2.3 在过桥处于水平位置时做伸缩试验，从开始起动至停止工作，其伸缩速度大约为0.5m/s。 A speed of approx.0.5m/s should be obtained when driving the telescopic in and out in horizontal position. 功能正常，签字,日期 Test OK. Signature and date 3.0 起升系统的功能测试（测量基准点为过桥端部着陆支座底部） Functional test of lifting system (measured from the end of the landing cone) 3.1 在完全收回位置起升过桥，测量起升速度：从0到5m，起升时间不超过8s。 Lift the bridge form the retracted position. Measure the lifting speed. Lifting from 0to 5m, lifting time is to be not more than 8 seconds. 功能正常，签字,日期 Test OK. Signature and date 3.2 在完全伸展位置起升过桥，测量起升速度：从0到5m，起升时间不超过12s。 Lift the bridge form the extended position. Measure the lifting speed. Lifting from 0to 5m, lifting time is to be