c533-95中文版-硅酸钙砖和管道绝热的标准规范.docVIP

C 1160 PAGE 775 Designation: C 533 - 95编号：C 533 - 95 PAGE 766 Standard Specification forCalcium Silicate Block and Pipe Thermal Insulation This specification is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C 16.20 on Homogeneous Inorganic Thermal Insulations.Current edition approved Aug. 15, 1995. Published October 1995. Originally issued in 1964 to replace C 344 and C 345. Last previous edition C 533 - 85 (1990). 本规范由ASTM委员会C-16隔热材料委员会管辖，并由C16.20均质无机绝热材料分委会直接负责。现行版本于1995年8月15日批准，并于1995年10月出版。最初版本于1964年出版以取代C344和C345。上一版本为C533-85（1990）。硅酸钙砖和管道绝热的标准规范 This specification is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C 16.20 on Homogeneous Inorganic Thermal Insulations. Current edition approved Aug. 15, 1995. Published October 1995. Originally issued in 1964 to replace C 344 and C 345. Last previous edition C 533 - 85 (1990). 本规范由ASTM委员会C-16隔热材料委员会管辖，并由C16.20均质无机绝热材料分委会直接负责。现行版本于1995年8月15日批准，并于1995年10月出版。最初版本于1964年出版以取代C344和C345。上一版本为C533-85（1990）。 This standard is issued under the fixed designation C 533; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval. 本标准以固定编号C533刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 This specification covers calcium silicate block and pipe thermal insulation for use on surfaces with temperatures between 80 and 1700℉ (27 to 927℃), unless otherwise agreed upon between the manufacturer and the purchaser.除非制造商和买方协商确定，否则本规范包括在温度为80℉-1700℉（27℃ 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 采用英寸-磅单位