c550-95中文版-刚性绝热块板的平直度和垂直度标准试验方法.docVIP

C 550 PAGE 212 Designation: C 550 – 95编号：C 550 - 95 PAGE 208 Standard Test Method forMeasuring Trueness and Squareness of Rigid Block andBoard Thermal Insulation This test method is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.32 on Mechanical Properties.本试验方法由ASTM委员会C-16绝热委员会管辖，并由C16.3 This test method is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.32 on Mechanical Properties.本试验方法由ASTM委员会C-16绝热委员会管辖，并由C16.32机械性能分委会直接负责。Current edition approved Jan. 15, 1995. Published March 1995. Originally published as C 550 - 64 T. Last previous edition C 550 - 81 (1987) ε1.现行版本于1995年1月15日批准，并于1995年3月出版。最初版本编号为C550-64。上一版本编号为C550-81（ This standard is issued under the fixed designation C 550; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 550刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense. Consult the DoD Index of Specifications and Standards for the specific year of issue which has been adopted by the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。对于（美国）国防部采用的具体刊发年份，请查阅（美国）国防部规范与标准索引。 1. Scope适用范围 This test method covers locations for measuring the trueness and squareness of rigid block/board thermal insulation. This test method does not purport to address the variability in board thickness. Thickness is addressed in other ASTM standards.此试验方法仅针对刚性绝热块/板的平直度和垂直度的测量点，而不包括刚性绝热板的厚度变化性，厚度变化性详见ASTM的其他标准。 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.以英制单位表示的数值视为标准，而