c1386-98中文版-预制高压蒸养加气混凝土（PAAC）墙体结构件（单元）的标准规范.docVIP

C 1386 PAGE 922 Designation: C 1386-98编号： C 1386-98 PAGE 921 Standard Specification forPrecast Autoclaved Aerated Concrete (PAAC) WallConstruction Units This specification is under the jurisdiction of ASTM Committee C-27 on Precast Concrete Products and is the direct responsibility of C27.20 on Architectural and Structural Products本规范受ASTM委员会C-27预制混凝土制品委员会管辖，并且由C27.20建筑结构制品分委会直接负责。Current edition approved Feb 10, 1998. Published September 1998.现行版本于1998年2月10日批准，并于1998年9月出版。预制高压蒸养加气混凝土 This specification is under the jurisdiction of ASTM Committee C-27 on Precast Concrete Products and is the direct responsibility of C27.20 on Architectural and Structural Products本规范受ASTM委员会C-27预制混凝土制品委员会管辖，并且由C27.20建筑结构制品分委会直接负责。Current edition approved Feb 10, 1998. Published September 1998.现行版本于1998年2月10日批准，并于1998年9月出版。 This standard is issued under the fixed designation C 1386; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 1386刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 This specification covers solid nonload-bearing and load-bearing precast concrete wall units made from autoclaved aerated concrete. Precast autoclaved aerated concrete (PAAC) is a cementitious product based on calcium silicate hydrates in which low density is attained by the inclusion of an agent resulting in macroscopic voids and is subjected to high- pressure steam curing. The precast autoclaved aerated concrete wall units are large-size solid rectangular prisms, which are to be laid using thin-bed mortar. Installed units covered by this specification shall be protected against direct exposure to moisture using a coating material accepted by the PAAC manufacturer.本规范包含了由高压蒸养加气混凝土制造的实心非