注塑产品模具可行性分析(DFM)教学教材.pptVIP

Draft angle information Cavity Core side Cavity side 前模此处位置倒扣，需修改 These position have undercut need to modify 产品周圈无出模斜度，建议减胶拔模出后模 This position around the Parts do not have demolding draft angle，need to modify Part Issue one 客户下来检查数据 Draft Analysis information-Core side Cavity side Core side 后模所有未拔模面建议减胶拔模1°以上 At the Core side， all these surface need reduce plastic make draft angle more then one degree. Part Issue two 客户确认更改 Cavity Lifter Slider Customer comment. (please give your approval and comments) OK or NG remark Approval by: date Notes: please advice any concern on witness line form by lifter. 此处位置倒扣，为简化模具结构和生产稳定，建议修改。Undercut position need to modify 建议修改成这种枕位可以成型的特征（左右两侧）Suggest modify like this (both are the same) Part Issue three PPT乐新更新得更详细， * SHENZHEN LOSANG PRECISION MOULDCD.,LTD * SHENZHEN LOSANG PRECISION MOULDCD.,LTD 以人文的精神关心人 以严格的管理培育人 * Confidential THANK YOU S401 Rear Frame DFMCAD version number：95_23335_A01 Product information REV Date Update or added sliders Remark: Segment : / Thickness : 2MM Project name : S401 PM/PE / Part name : Rear Frame DFM by: XIAO Part No: 95_23335_A01 Checked by: qing 3D Rev 95_23335_A01_-___FRAME_REAR_CA_S401______________3DORG____1_1___0_______0225 产品尺寸 Product size：311.06*935.6*62.4 Cavity and core Impression Cavity Core Tool information Resin material : PP LGF 40 Resin supplier: Ticona Celstran PP-LGF 40-2 Resin Grade Tonnage N/A Runner Sys: Hot runner No. of Hot Tip 3 point HRS Or Synventive Tool type : 2 plate Gate type : 针阀式转冷流道进胶 3 point valve gates turn to edge gate Automatic: YES No. of Gate. (Each part) 3 Part weight (g) : 666G Cavity steel S50C/1.2343 Forecast volume (shot) N/A Special tool : N/A Core steel S50C/1.2343 No. of Cavity: 1 Cosmetic part (Y/N): N Slider steel S50C/1.2343 Family with: S401 Cosmetic finishing N/A Lifter and small insert steel 1.2344 Need your input and correction to below information: Customer comment. (please give your approva