优赛德 热氮气喷涂培训 PPT资料讲解.ppt

参考案例 #1 - automotive NITROTHERM SPRAY ADVANTAGES: No sag Thickness uniformity (15mic, with air between 8 and 25) Atomization pressure reduced by half (from 4.13bar to 2,07bar) -30% paint consumptions -25% application time Perfect quality around the holes Toyota Products treated with Nitrogen: Bumpers 65 Eurosider machines: J40, J30, J20 Locations: USA, UK, CAN, FRA, CHECK REP Application line: Only manual application and mainly primer /watch?v=2ovcCgt-Etg 参考案例 #2 – yatch and gel coating NITROTHERM SPRAY ADVANTAGES: Gel coat 800um is applied by manual painting of the mold using Nitrotherm; basically one layer applied in 3 movements of the gun each about 250 um. Total application time about 0.5 hr. No dripping. Gel coat is high density coating and when applied manually by roller it takes 20 x longer then with Nitrotherm due to the flash times needed in between Pressure reduction -25% +5% yield improvement. Azimut Products treated with Nitrogen: Panels 5 Eurosider machines: J40 Locations: ITA Application line: Only manual application /watch?v=HnmvEUcw2Ls 参考案例 #3 – automotive NITROTHERM SPRAY ADVANTAGES: Defects Per Vehicle (-22,72%); VOC Emissions (-23,2%); Solvent Consumption (-28,5%); Paint Consumption (-24,3%); Application Time (-22,2%); Productivity (+22,2%); Overspray (-16,3%); Transfer Efficiency (+20,9%). Faurecia Products treated with Nitrogen: Bumpers 11 Eurosider machines: J90 Locations: GER Application line: Rotary bells robot line /watch?v=JIUd4-d8SuM 参考案例 #4 – furniture NITROTHERM SPRAY ADVANTAGES: -30% paint consumptions -25% application time Perfect quality around the holes, due to the excellent adhesion of the pain, also in the corners. -90% reduction of micro bubbles between surface and the coating No dripping Ilcam Products treated with Nitrogen: Cabinetry 8 Eurosider machines: J20, J40, J80 Locations: Italy Application line: Automatic guns /watch?v=Th9xroZQRkk * 参考案例 #5 – automotive NITROTHERM SPRAY ADVANTAGES: VOC reduction