ikarct基本型加热磁力搅拌器使用说明.doc

5005525a_RCT_HCT_052010:RCT basic 8/13/2010 5:18 PM Page 1 50 055 25 a RCT basic safety control RCT 基本型(安全控制型) 加热磁力搅拌器 HCT basic safety control HCT 基本型(安全控制型) 加热板 Operating instructions EN 4 使用说明 CN 14 062010 5005525a_RCT_HCT_052010:RCT basic 8/13/2010 5:18 PM Page 3 RCT basic safety control HCT basic safety control RCT 基本型 (安全控制型) HCT 基本型 (安全控制型) A B L K A B L K M F M D C J J C E E G H I G H I Fig. 1 Fig. 2 Item Designation 序号 名称 A Main Switch B Adjustable safety circuit C Rotary knob, heater A 电源开关 B 安全温度设定螺丝 C 调温旋钮 D Rotary knob, motor E LED display, heater D 调速旋钮 E 温度显示 F LED display, motor G LED, heating plate H LED, external temperature sensor F 转速显示 G 加热指示 H 外部温度计指示 I LED (set=set point value) J LED, external temperature sensor I 设定指示 J 外部温度计指示 K Power socket L Socket, contact thermometer M Threaded hole for stand K 电源插口 L 温度计插口 M 支杆螺孔 3 062010 5005525a_RCT_HCT_052010:RCT basic 8/13/2010 5:18 PM Page 4 Contents - splashing and evaporation of liquids - ejection of parts EN - release of toxic or combustable gases. Page ? Set up the appliance in a spacious area on an even, stable, clean, non-slip, dry and fireproof surface. Safety instructions 4 ? The feet of the appliance must be clean and undamaged. Unpacking 6 ? Check the appliance and accessories beforehand for damage Correct use 6 each time you use them. Do not use damaged components. Operation 7 ? Gradually increase the speed. Setting the operating mode 8 ? Reduce the speed if Setting the safety temperature limit 8 - the medium splashes out of the vessel because the speed is too high Setting the temperature control mode 9 - the appliance is not running smoothly Assembling the stand 9 - the container moves on the base plate. Maintenance 10 ? Caution! Only process and heat up any media that has a flash Accessories 10 point higher than the adjusted safe temperature limit that has Error codes 11 been set (50 to 360 °C). Technical data 12 The safe temperature limit must always be set to at least 25 °C Wa