MTBF-公式介绍word版本.docVIP

MTBF-公式介绍 精品文档 精品文档 收集于网络，如有侵权请联系管理员删除 收集于网络，如有侵权请联系管理员删除 精品文档 收集于网络，如有侵权请联系管理员删除 MTBF Introduction 利用加速寿命试验的手法及增加取样数量的方式，来缩短测试产品出现失效的时间，以便在短期内达到符合产品的平均失效间隔时间MTBF (Mean Time Between Failure)，进而保证产品在可用期的可靠度。其实施步骤可参考「平均失效间隔时间验证作业程序」 (TG-SX00-Q066) It is using accelerated life tests and increasing sample sizes to shorten the failure time of products so that we can reach the MTBF(Mean Time Between Failure) for products in a short period. As to its procedures, we can refer to “MTBF prediction/Demonstration Standard”(TG-SX00-Q066). (1). 根据客户要求之测试条件及标准，计算出在正常环境下累积MTBF所需的时间(T)。 Calculating the required time (T) being accumulated as MTBF in normal environment according to the demanded test conditions and criteria of customers’. (a). MTBF之累积一般均采用单阶时间检剔数据法(即预先设定试验截止的时间点)，在试验中若发现不良品，就必须参考固定时间试验GEM(Generalized Exponential Model)表，计算出累积MTBF所需的时间。由GEM表之试验比，可以看出不良数越多，则累积MTBF所需的时间(T)越长。 Time screening method is generally used for the accumulation of MTBF. If there is any defected sample found during testing, it is a must to calculate, referring to fixed time tests GEM (Generalized Exponential Model), the time needed toaccumulate MTBF. It can be seen that the more failure quantity is, the longer time (T) is needed to accumulate MTBF. 试验比(M) == T = M ? 试验比(M) = = T = M ? MTBF 累积MTBF所需的时间 Time needed to accumulate MTBF (T) 平均失效间隔时间 Mean time interval for failure (MTBF) (b). 使用GEM表须按照客户指定的信赖水平来查表，若客户无特别要求，则建议选择90%信赖水平为基础，此为目前业界常用的水平。 We must follow the confidence level assigned by customers to use GEM table. Confidence level of 90%, which is the most common used in the field, is suggested to be adopted. (c). 在试验中若发现不良品，则将不良品修复，并登记一次不良。修复之不良品，可继续加入试验累积MTBF，同一件产品可重复修复，直到无法修复为止。 If there is any NG sample found, it should be repaired and this log needs to be recorded. Repaired NG samples can continue being tested to accumulate MTBF, and one product can be repaired repeatedly until it can not be repaired anymore. (d). 假设