（电力行业）某涉外项目(中英双语版)电缆桥架安装施工方案.pdfVIP

（电力行业）某涉外项目 (中英双语版)电缆桥架安 装施工方案 METHORD STATEMENT FOR CABLE TRAY INSTALLATION 电缆桥架施工方案 版本 Rev. 编制 Prepared by 审核Reviewed by 批准 Approved by 认可 Accepted by Contents 目 录 １、 工程概述1 General1 ２、适用范围1 Scope of work1 ３、 编制依据1 References1 ４、 施工准备2 Preparation for construction2 5 、　 桥架安装技术要求 4 Technical Requirements for Cable Tray Installation4 ６、 桥架施工工序 8 Cable tray installation procedure8 ７、 施工详细描述8 Installation description8 ８、 施工注意事项及措施11 Construction precaution and measurement to be taken11 9 、 施工特别措施13 Special measurement to be taken in construction13 10 、 脚手架搭设描述及注意事项15 The procedure of setting up scaffold and precaution15 11 、(JHA)25 工作安全分析25 １、 工程概述 General 为了保证电缆桥架安装工作正常有序地进行,力求施工周期最短、确保技术、安全可靠 的方案编制原则，根据国家、业主的规范要求，特编制此电缆桥架安装施工方案，以 说明安装过程中施工方法、施工用料、施工顺序。 In order to ensure normal and proper field installation for electrical and instrument cable tray safe successful completion of the work, this installation procedure is specially prepared as per the national standards and the Owner’s specification requirements in the principle of lowest construction cost, shortest construction duration and safe reliable technology to elaborate the installation construction method, construction materials and installation sequence ２、适用范围 Scope of work 本方案适用于拜耳聚碳酸酯 SPCII/LOGII 项目桥架施工，包括管廊桥架、B204 区域、 B244 区域、B209 区域、B252 区域、B221 区域、B222 区域桥架施工及其它区域桥架 施工。 This scope describes the activities to be performed by the Contractor for the Works and Services as specified below for Bayer SpcII/LogII cable tray installation, including outside pipe rack area, B204, B252,B209,B244,B221,B222 area and other area which need to be