原创：CCIE 之开放最短路径优先(OSPF)综合实验.docVIP

QQ:409396869 一. 实验环境 用gns3模拟本次实验环境, 分别有r0 r1 r2 r3 r4 r5 r6 r7 r8 r9。其中r0做帧中继交换机 二. 实验目的 开放最短路径优先协议（OSPF ）综合实验： 三. 实验拓扑 四. frame-switch#show frame-relay lmi LMI Statistics for interface Serial1/0 (Frame Relay DCE LMI TYPE = ANSI Invalid Unnumbered info 0 Invalid Prot Disc 0 Invalid dummy Call Ref 0 Invalid Msg Type 0 Invalid Status Message 0 Invalid Lock Shift 0 Invalid Information ID 0 Invalid Report IE Len 0 Invalid Report Request 0 Invalid Keep IE Len 0 Num Status Enq. Rcvd 90 Num Status msgs Sent 90 Num Update Status Sent 0 Num St Enq. Timeouts 59 LMI Statistics for interface Serial1/1 (Frame Relay DCE LMI TYPE = ANSI Invalid Unnumbered info 0 Invalid Prot Disc 0 Invalid dummy Call Ref 0 Invalid Msg Type 0 Invalid Status Message 0 Invalid Lock Shift 0 Invalid Information ID 0 Invalid Report IE Len 0 Invalid Report Request 0 Invalid Keep IE Len 0 Num Status Enq. Rcvd 23 Num Status msgs Sent 23 Num Update Status Sent 0 Num St Enq. Timeouts 94 Invalid Unnumbered info 0 Invalid dummy Call Ref 0 Invalid Status Message 0 Invalid Information ID 0 Invalid Report Request 0 Num Status Enq. Rcvd 67 Num Update Status Sent 0 Invalid Prot Disc 0 Invalid Msg Type 0 Invalid Keep IE Len 0 Num Status msgs Sent 47 Num St Enq. Timeouts 50 broadcast, CISCO, status defined, broadcast, CISCO, status defined, r3# 2. 偶是平凡 原创：CCIE 之开放最短路径优先（OSPF ）综合实验 *如果也没有loopback 地址那么就选择物理接口中ip 地址高的作为router-id 3 OSPF Area Commands *明文认证 Area area-id authentication *area-id 0-4294967295或者-55 *同时在物理接口上启用 ip ospf authentication-key password *在区域0使用认证的虚电路： Area transit-area virtual-link router-id authentication key password 偶是平凡 原创：CCIE 之开放最短路径优先（OSPF ）综合实验 QQ:409396869 *MD5认证 Area area-id authentication message-digest *在物理接口上启用ip ospf message-digest-key key-id md5 password *虚电路上area transit-area virtul-link router-id message-diges-key key-id md5 password 4 虚链路 Area transit-area-id virtual-link router-id 所有非0区域必须具有到骨干区域的连接，虚链路用于修复被修复被分割的区域，但传送区域不能为stub 区域。 虚链路的规则：虚链路必须配置在两台abr 路由器之间。 样的区域又被称为传送区