ASME SECTION II C SFA-5.3-SFA-5.3M-2008 国外国际规范.pdf

2008a SECTION II, PART C SFA-5.3/SFA-5.3M SPECIFICATION FOR ALUMINUM AND ALUMINUM- ALLOY ELECTRODES FOR SHIELDED METAL ARC WELDING SFA-5.3/SFA-5.3M [Identical with AWS Specification A5.3/A5.3M:1999 (R2007). In case of dispute, the original AWS text applies.] A08 1. Scope 3. Classification This specification prescribes requirements for the 3.1 The electrodes covered by the A5.3/A5.3M speci- classification of aluminum and aluminum-alloy fication are classified using a system that is independent electrodes for shielded metal arc welding. of U.S. Customary Units and the International System of Units (SI). Classification is according to the chemical com- PART A — GENERAL REQUIREMENTS position of the core wire, as specified in Table 1, and 2. Normative References mechanical properties of a groove weld. 2.1 The following ANSI/AWS standards1 are refer- 3.2 An electrode classified under one classification shall enced in the mandatory sections of this document: not be classified under any other classification in this speci- (a) ANSI/AWS A5.01, Filler Metal Procurement fication. Guidelines. (b) ANSI/AWS B4.0, Standard Methods for Mechani- cal Testing of Welds. 4. Acceptance