WSS-M4D873-A4-2006 国外国际规范.pdfVIP

ENGINEERING MATERIAL SPECIFICATION THERMOPLASTIC POLYOLEFIN ELASTOMER (TEO) WSS-M4D873-A3 20% MINERAL FILLED, LOW THERMAL EXPANSION, HIGH IMPACT MOLDING COMPOUND, EXTERIOR THERMOPLASTIC POLYOLEFIN ELASTOMER (TEO) WSS-M4D873-A4 20% MINERAL FILLED, LOW THERMAL EXPANSION, HIGH IMPACT MOLDING COMPOUND, PAINTABLE NOT TO BE USED FOR NEW DESIGN 1. SCOPE The materials defined by these specifications are 20% mineral filled high impact and very low thermal expansion thermoplastic polyolefin elastomer (TEO) injection molding compounds based on in-reactor alloyed polypropylene copolymers and rubber, color pigmented and added UV stabilization for exterior use (WSS-M4D873-A3) or suitable for painting, providing that suitable surface pretreatment is used (WSS-M4D873-A4). 2. APPLICATION These specifications were released originally for material used for bumper shells or other parts of bumper system, pigmented and/or painted. 3. REQUIREMENTS 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1.1 All requirements of this specification, identified by symbol (s), shall be met with data representing 3 sigma values. 3.2 MOLDING COMPOUND (s) 3.2.1 Melt Flow Rate, 13 - 20 g/ 10 minute (ISO 1133, 230 °C, 2.16 kg) (s) 3.2.2 Filler Content 18 - 23%