ABBubb型有载调压分接开关.pdfVIP

On-load tap-changers Selection guide During selection several important factors have to be considered to ensure that the correct equipment is chosen. This Selection Guide has been produced to simplify the selection process and to ensure that sufficient information exists to allow the correct selection to be made. The technical information pertaining to on-load tap-changers manufactured by ABB Power Technology Products has been divided in separate documents, with one document for each type. The information provided in this document is intended to be general and does not cover all possible applications. Any specific application not covered should be referred directly to ABB, or its authorized representative. ABB makes no warranty or representation and assumes no liability for the accuracy of the information in this document or for the use of such information. All information in this document is subject to change without notice. Table of contents The selection process ___________ 3 Input data ____________________ 4 On-load tap-changer range _______ 5 On-load tap-changers ___________ 6 Motor-drive mechanisms _________ 7 2 The selection process Below is a schematic plan, showing the selection made in the applicable Technical Guide. In the process. Before the selection can start, certain input Technical Guide, the special features are chosen. The data has to be collected. After that the selection guide order data form can then be completed and sent to can be a help to select the most suitable tap-changer for ABB, either by using the traditional ordering data sheets the application in question. When the type of tap- or by using the electronic version,