ControlWave系统openBSI软件培训资料.ppt

Bristol Babcock;DCS-Distributed Control System集散型控制系统 SCADA-Supervisory Control And Data Acquisition 监控控制和数据采集 RTU-Remote Terminal Unit 远程终端单元 BSAP - Bristol Synchronous / Asynchronous Protocol.BB同/异步协议 PLC-Programable Logic Controller可编程逻辑控制器 Open BSI - Open Bristol System Interface开放式BB系统接口 NHP - Network Host PC 网络主机;OpenBSI是一个基于Window95/NT的通讯接口软件，它提供了一个通用的通讯层，其它的BB和非BB应用接口可以通过这个通讯层与Network3000产品进行通讯，OpenBSI支持电台直接连接和自动拨号系统。在这个通讯层上面包含了一组应用工具，也就是常说的OpenBSI Utilities。 基本的工具提供在线的信号数据访问、ACCOL文件下载以及通讯状态监视。数据采集器和计划表使得历史数组及报警/事件追踪记录采集成为可能，这些文件自动地转换成CSV或与ODBC兼容的文件格式。 ;;OPENBSI工具软件;OPENBSI工具软件;;LocalView is a Windows? based tool which operates in three distinct modes, each of which is described, below. LocalView allows the user to: Local Mode. Establish communications (via BSAP) with a locally attached Network 3000-series controller or ControlWave process automation controller to allow access by Open BSI tools (DataView, Downloader, etc.) This operation is referred to as Flash Mode Perform a download of system firmware into the locally connected Network 3000-series controller. This option is used for field upgrades of system firmware. This operation is referred to as. Flash Mode is NOT supported for ControlWave or ControlWaveLP controllers. Configure Mode Configure IP addresses, and port parameters for a locally connected 386EX Protected Mode controller, a ControlWave controller, or a ControlWaveLP controller. ;通讯端口;自动查找就地 控制器地址选择;;使用LOCALVIEW启动其它程序;;;Specifying Ethernet Port Parameters The Ethernet port parameters specify the IP address of this RTU’s Ethernet port(s), as well as the range of IP addresses to which this RTU can send messages. The Ethernet Port Parameters are accessible by clicking on the ’ENET’ port in the Ports list box.;IP ADDR A this is the IP address of the Ethernet Port on the ’A’ unit of a redundant pair of RTU’s, or of the current RTU if it is NOT part of a redundant pair. This address must be in dotted decimal format, and must be uniqu