ds_nios2_3c120_lcd全 参考 学习文档.pdf

Nios II 3C120 Microprocessor with LCD Controller Data Sheet DS-01002-1.1 © March 2009 Introduction This data sheet describes a single instance of a Nios® II-based processor system with a built-in LCD controller targeted for an Altera® Cyclone® III 3C120F780 FPGA on the Altera Embedded Systems Development Kit, Cyclone III Edition. The Nios II 3C120 Microprocessor with LCD Controller is a complete system-on-a-programmable-chip (SOPC) solution that incorporates a rich set of system peripherals and standard interfaces for a wide range of embedded applications involving video processing and LCD touch panel control. The key benefit of implementing a processor system in an FPGA is that you can customize your system using intellectual property (IP) cores, custom logic, and hardware acceleration to optimize to your target application. Nearly every feature in the system is available for you to configure, customize, duplicate, or remove easily. You can further enhance your system by adding additional IP to the Cyclone III 3C120 device, or you can remove IP or select options that reduce logic utilization allowing you to port to a smaller device to reduce cost. 1 Although this data sheet describes a system targeted for the Cyclone III 3C120 FPGA device, the data sheet also shows you how to configure the processor system for another Altera FPGA devic