EX_Direct Transient Response_bdf全 参考 学习文档全 参考 学习文档.pdfVIP

Problem #3 Direct Transient Response NAS102 2004, 1 NAS102 2004, 1 Problem #3 - Direct Transient Response Using the direct method, determine the transient response of the flat rectangular plate, created in Problem 1, subject to time-varying excitation. This example structure is excited by 1 psi pressure load over the total surface of the plate varying at 250 Hz. In addition, a 50 lb force is applied at a corner of the tip also varying at 250 Hz, but 180o out-of-phase with the pressure load. Both time dependent dynamic loads are applied for the duration of 0.008 seconds only. Use structural damping of g=0.06 and convert this damping to equivalent viscous damping at 250 Hz. Carry the analysis for 0.04 seconds. Below is a finite element representation of the flat plate. It also contains the loads and boundary constraints. 1 p s i o v e r t h e t o t a l s u rf a c e 5 0 . 0 0 Figure 7-1. Loads and Boundary Conditions. NAS102 2004, 2 NAS102 2004, 2 Solution File For Problem #3 $ $ soln3.dat $ $ $ SPECIFY STRUCTURAL DAMPING ID SEMINAR, PROB3 $ 3 PERCENT AT 250 HZ. = 1571 RAD/SEC. SOL 109 $ CEND PARAM, G, 0.06 TITLE= TRANSIENT RESPONSE WITH TIME DEPENDENT PARAM, W3, 1571. PRESSURE AND POINT LOADS