设计存在问题20150903.docxVIP

临时工程设计需咨询的问题 The problems to consult about temporary works Design for Western?Segment?of?the?Red?Line 1．请提供一下以色列规范中钢筋混凝土变形缝的设置间距及设置原则（龙门吊基础是否需要设置伸缩缝）。 1．Could you please offer us the principles and the movement joint interval of reinforced concrete in Israel specifications? Or confirm whether the gantry crane foundation is needed to set the movement joints? 2．以色列规范中钢筋等级和钢筋符号的划分。 2．Could you give us an explicit table about the grade and symbols of steel bar in Israel specification? 3．以色列规范中混凝土等级划分及各等级的设计强度指标。 3.Could you give us an explicit table about the grade and symbols of concrete in Israel specification? 4．地质报告中无承载力特征值，以色列规范中是否有地基承载力的相关说法及计算公式？ 4. We cannot find the parameters of bearing capacity of subgrade in Geological Report, whether the Israel specification have the formula or standard about the value of bearing capacity? 5．以色列规范中钢结构抗弯、抗剪、拉弯、压弯、挠度、稳定性验算公式是否与欧标一致。（目前我们设计是参照欧标规范的） 5．Whether the checking formula of steel structure in EN about the bending, shearing, stretch bending, buckling, deflection and reliability have the similar principles to the Israel specification? (Currently, we are referring to the European standard, is that ok?) 6．以色列规范中钢筋混凝土结构的抗弯、抗剪、抗压、压弯、挠度、裂缝宽度验算、最小配筋率的要求公式是否与欧标一致。（目前我们设计是参照欧标规范的） 6．Whether the formula of RC structure in EN about the bending, shearing, compressive, buckling, deflection, crack width and minimum ratio of reinforcement has the similar principles to the Israel specification？(Currently , we are referring to the European standard, is that ok?) 7．以色列的H型钢、工字钢、螺栓型号规格是否与欧标一致。 7．Whether the Israel’s H-section steel, I-steel and bolt have the similar types to the EN specification 8.欧标中关于混凝土结构局部抗压能力验算的公式如下，以色列规范中关于混凝土局部受压的计算是否与欧标一样？ For partially loaded areas, local crushing (see below) and transverse tension forces shall be considered. For a uniform distribution of load on an area Ac0 (see Figure 1 as follow), the concentrated resistance force may be determined as follows: Where: Ac0 is the loaded area, Ac1 is the maximum