学习笔记手册.docVIP

F:\CT学习资料\Aq16 training\10_Training_Sheets\6_Aseries Super4\H_Operation_Software（系统软件，IP信息设置，软件检测） 1.CT排数的概念 “排”是指CT扫描机探测器的阵列数，一般排数越多，探测器宽度越宽，一次扫描完成的宽度越大。有人将多“排”CT称为多“层”CT(multislice CT，MSCT)，在一般情况下两者的含义相同，即有多少“排”探测器，一次扫描即可完成多少“层”图像的采集。但是,如果每排探测器一次采集重建出2层图像,例如,西门子64层CT,实际探测器是32排,每排出2幅图像,因此一次采集可以形成64层图像。CT技术的不断发展，使MDCT在心脏检查方面，无论在扫描时间上，还是在冠状动脉诊断的敏感性和准确性上都有明显提高，如：64排CT较以往16排CT扫描速度加快，由0.42～0.50 s/周提高到0.33 s/周，一次心脏扫描仅需8～10 s 2.DCA参数调节 DCA 进入参数详细调节明细 Acq.Detail Don’t use Scan Times 0.25sand 0.4son 0.5ssystems Slice Widthis detector element row bundling for one row Slitis the opening for one slice - Slit-Nis the number of slits 支付宝账户名835463891@ TIf a door switch is provided at the entrance of the scanning room, the door switch connection signal is connected between terminals 5 and 6 of the DR-SW terminal of TB3. Unless the door switch is closed, the system is not set up and no X-rays are output. NOTE: Output for detection 24 VDC 10 mA 1Front/Rear Tube Alignment (a) Click [Utility] in the Command Box and then click [Engineering];Enter the password and click [OK]. The window shown in figure 3.2-2 is displayed. (c) Select [Alignment] from the window shown in figure 3.2-2. The interactive window shown in figure 3.2-3 is displayed. (d) Select [Front/Back] from the Mode area in the displayed interactive window shown in figure 3.2-3. (e) Select [Scan to calculate]. The scan start key on the keyboard lights. When the scan start key is pressed, the following operations are performed automatically. ? 0.75-s/rot. scanning is performed twice. ? Calculation is performed and the results are displayed. (Refer to figure 3.2-4.) (f) The results are displayed in the Measured Data area. When the dialog window is closed, the results are automatically registered in the Registered Data area. (g) When the result is within the standard range, the alignment is complete. If the result isoutside the standard range, adjust the X-ray tube position based on the disp