基于单片机单相数字电功率表的设计.pdfVIP

摘要 本文主要讲述了基于单片机的单相数字电功率表的设计。该单相数字功率表 采用 AT89C52 单片机作为中央处理器，其间通过检测电压电流值，采用过零比较 法利用单片机的定时器计算出相位角  ，最后依据 P  UI COS 得出电网功率，最后 将检测到的测量值显示在液晶显示器上。另外本文 介绍了其相关硬件电路和软件 程序流程图，本设计主要包括下面几方面：交流信号数据采样与处理、模数转换、 单片机应用与编程、液晶显示。随着社会的发展，电子产品逐渐朝着数字化、信 息化、自动化方向发展，本设计的数字功率表也逐渐取代了传统指针式模拟功率 表，其具有抗干扰能力强、精度高、可扩展性强、集成方便等优点，具有 良好的 研究意义。 关键词：单片机 数据采集 过零比较 液晶显示 Abstract This paper describes the design of single-phase digital electric power meter based on MCU.The single phase digital power meter using AT89C52 microcontroller as the central processor, which by detecting the voltage and current value, the zero crossing comparison method the use of single-chip timer to calculate the phase angle , finally based on P  UI COS the results of the power, the measurement of the detected value displayed on the LCD monitor.This paper also introduces the related hardware circuit and software program flow chart, the design mainly includes the following aspects: sampling and processing, analog- to-digital conversion, application and programming, MCU LCD AC signal data.With the development of society, electronic products gradually towards digitization, informatization, automation development direction, the design of the digital power meter has gradually replaced the traditional analog pointer type power meter, it has advantages of strong anti- interference ability, high precision, strong expansibility, easy to be integrated, with good research significance. Keywords:microcontroller data acquisition more than zero liquid crystal display I