openwrt下安装mwan3做负载均衡.docxVIP

openwrt下安装mwan3做负载均衡 安装 mwan3 1. opkg updata #更新安装包 2. opkg list | grep mwan #查看 mwan 安装包歹U表 3. opkg in stall luci -app- mwan3 4. opkg in stall mwan3 5. #分别安装这2个包 web界面设置 找到菜单栏Network-Load Balancing ，可以看到负载均衡的界面，由于路由器本身已有 Wan1 口，所以接下来分别添加 Wan2和Wan3 口. Network-I nteface 下，点 Add new in teface,Name of the new in terface :填 wan2 Protocol of the new in terface :选PPPoE或DHCP，看运营商给你的光纤类型 Cover the follow ingin terface :选新增接口对应的物理网卡地址，我这里是 eth2 填完点Submit，会转到PPPoE界面，填入接入商提供的用户名密码，点 save，依次添加 Wan3 接口 Bring up on bool Bring up on bool UNSAVED CHANGES: 96 AUTO REPLEDE UNSAVED CHANGES: 96 AUTO REP On this ppg色 you can eonfigurs th电 network interfaces Ygu can bridgs several interfa.c：e$ by ticking lhe bridge hlerface^ field and Qnl@r lhe names of e net^gric hterfsces separated by spaces Yoo can also use VLAN notation dtterfwx VLANIE 塩:q 住伽瓜 1） Common Configuration Phystcal Settings Firewall SellingsGeneral Stup Advanced Settings Phystcal Settings Firewall Sellings Use buillin IPv6-mtanagefnenl Automatic Use default gatev^ay 萨专 If unchecked, no defaull iroule is configured Use gateway metric 40 # 0 If # 0 If unchecked. Ihe advertid DNS serve『addresses are ignore-d ILCP echo failure Ihreshold ? Presume peer to b@ dead after given 百mount of LCP echo failure us■色□ to Ignore failures. LCP echo inlerv^l 紆 Send LCP echo requests at the given Interval in seconds, only effecllve in conjundiodi with railuire threshold hadivity limeoul O Ck?e in a dive conneclion after the given amount of seconds, use 0 Io persist connection Override MTU 更改每个Wan口的跃点数 Network-I nteface-Wan 1-edit-Adva need Sett in gs-Use gateway metric, 分另 U 填 40 , 41 , 42 配置 MWAN3 点 Network-Load Balancing-Configuration-lntefaces ，删掉多余的接口，左 下角Add处填 Wan1,点Add, 在弹出的对话栏里， Tracking IP 填14 （最好填国内的 DNS）， 然后点save。依次创建 Wan2和 Wan3。 LEDE Slafuts = SyBtemi ▼ Network - Logout UMSAVED CHA.MGES:哪 MWAN Interface Configuration - Wan1 Enabled Yes ? Tracking I P 114114 114 114 口 ? This IP address wil be piinged to dermine if Che link is up