双语教学资源 其他书籍（双语文字稿） 24-（25）铁路电力设计规范.doc

Contents 目次 1 General Provisions 1总则 2 Terms 2术语 3 Basic Requirement 3基本规定 4 Power Supply and Distribution System 4供配电系统 4. 1 Classification of Loads and Requirements for Power Supply 4.1负荷分级及供电要求 4. 2 Power Source and Power Supply and Distribution System 4.2电源及供配电系统 4. 3 Power Supply Voltage Allowable Deviation and Reactive Power Compensation 4.3供电电压允许偏差和无功补偿 5 Substations & Power Distribution Substations 5变、配电所 5. 1 Location Selection and Arrangement 5.1所址选择及所区布置 5.2 Electrical Main Connection, Arrangement and Selection of Equipment 5.2电气主接线、设备布置及选择 5. 3 Pole-mounted Transformer & Box-type Substation 5.3变电台和箱式变电所 5. 4 Meters and Gages & Relay Protection Arrangement 5.4测量表计、继电保护配置 5. 5 Requirements for Relevant Specialties 5.5对有关专业的要求 6 SCADA (Supervisory Control and Data Acquisition) System 6电力远动系统 6. 1 General Requirement 6.1一般规定 6. 2 System Composition 6.2系统构成 6. 3 System Function 6.3系统功能 6. 4 Hardware and Software Configuration 6.4硬件、软件配置 6. 5 Telecontrol Channel and Telecontrol Communication Protocol 6.5远动通道及远动通信规约 6. 6 Main Technical Indexes of SCADA System 6.6电力远动系统主要技术指标 6. 7 Requirements for Relevant Specialties 6.7对相关专业的要求 6. 8 Working Condition and Environment Requirement 6.8工作条件及环境要求 6. 9 Power Supply 6.9电源 7 Overhead Electrical Power Transmission Line 7架空电力线路 7. 1 Path Selection 7.1路径选择 7. 2 Meteorological Conditions 7.2气象条件 7. 3 Conductor Selection and Conductor Arrangement 7.3导线选择及导线排列 7. 4 Insulator and Electric Power Fitting 7.4绝缘子和金具 7. 5 Pole and Tower, Stay Wire and Foundation 7.5杆培、拉线和基础 7. 6 Switchgear 7.6开关设备 7. 7 Distance to Ground and Crossing 7.7对地距离及交叉跨越 7. 8 Service Line 7.8接户线 8 Cable Line 8电缆线路 8. 1 Cable Selection 8.1电缆选择 8. 2 Selection of Cabling Laying Mode 8.2电缆敷设方式的选择 8. 3 Cable Laying 8.3电缆敷设 8. 4 Cable Accessories and Others 8.4电缆附件及其他 9 Low-Voltage Power Distribution 9低压配电 9. 1 Distribution System & Configuration and Option of Electrical Equipment 9.1配电系统及电器的配置和选择 9. 2 Options of Conducto