冠脉支架的长度缩短率和狗骨头率分析.docVIP

光学精密工程 Optics and Precision Engineering 文章编号 1004-924X( 2008 ) 01-0087-05 冠脉支架的长度缩短率和狗骨头率分析 谢冀江I,祁磊2 (1.中国科学院长春光学精密机械与物理研究所，吉林长春130033； 2?中国科学院研究生院，北京100049) 播要：用有限元法确定了所设计的冠脉支架膨胀后的长度缩短率和狗骨头率，以检验结构是否合理。用有限元分析软件 ANSYS模拟了支架单独自由膨胀过程?在不考虑球爱和血管壁的作用下研究了此支架从原始状态膨胀时的几何建模、 网格划分、边界条件和载荷定义等技术。根据有限元模拟结果计算得到支架长度缩短率为10.9%,狗骨头率为2.57%。 为了验证有限元分析的准确性?对实际加工岀来的支架进行了膨胀实验。计算得到实际膨胀后两个参数与有限元模拟 结果之误差分别为0.3%和1.32%,结果吻合较好，表明所设计的冠脉支架膨胀均匀、结构合理?同时也验证了用有限元 法进行冠脉支架模拟分析是可行的。 关 键 词：冠脉支架；有限元分析；势胀 中图分类号：R543.3;TH122 文献标识码：A Study on shortage ratio and dogboning ratio of coronary stent XIE Ji-jiang1, QI Lei1*2 (1. Changchun Institute of Optics ■ Fine Mechanics and Physics 9Chinese Academy of Sciences Changchun 130033,China ； 2. Graduate School of the Chinese Academy of Sciences 9Beijing 100049 tCAina) Abstract: The shortage ratio and dogboning ratio of a new style stent after expanding were calculated to determine whether the structure was reasonable. The expansion process of the unrestricted stent was simulated by Finite Element Analysis(FEA) software ANSYS^and the technology for stent expansion from its initial status, including geometry modeling, material selection, meshings boundary conditions and load definition was studied without considering artery and plaque. The shortage ratio and dogboning ratio of stent calculated by FEA are 10. 9% and 2. 57 % t respectively. To validate the simulation9 an expasion experiment of a real stent was doneand the experimental results proved that the errors between the real expansion results and the FEA results are 0. 3% and 1. 32% ? respectively. The results show that the expanded stent is uniformity and the structure design is reasonable? and u- sing FEA to simulate the coronary stent expansion is feasiblet which is advantageous to the design and the application of the stent. Key words： coronary stent ； Finite Element Analysis(FEA) ； expansion 收稿日期：2007-06-26;修订日期：2007-07-31. 基金项目：吉林省科技厅资助基础研究项目(No. 1引言 心血管疾病已经被公认为我国乃至世界危及 人们生命健廉的最严矗的疾病之一，其发病率和 死亡率居各