斯伦贝谢Next培训定向井PPT 02-02 Anti colllision and advanced well planning.pptVIP

* In order to avoid magnetic interference, non-magnetic drill collars must be used. In the past, empirical charts were used to estimate the length of non-magnetic material needed. These charts were valid at the time because most wells were kicked off to less than 10 degrees of inclination and often without a mud motor (whip stock, jetting, etc.). Experiments have shown that mud motors produce a magnetic field from 3 to 10 times greater than components such as steel stabilizers and short drill collars. As a rule of thumb, anytime a mud motor is run, a non-magnetic short drill collar (of 10 to 1