斯伦贝谢Next培训定向井PPT 03-01-2 General Equipment Overview.pptVIP

* The body of a string reamer is sometimes made from a short length of HWDP. The connections are usually the same as on the drillpipe. Blades are welded on the body. The blades are hard- faced. The blades may be either straight or tapered. The O.D. of the blades varies, but is never greater than the bit diameter. A more expensive design of string reamer is machined from one piece of steel and hard-facing then applied. A string reamer is normally run in the drillpipe. It is positioned in the drillstring so that, on reaching bottom, it is close to the top of the key-seat area. As drilling progre