手机结构设计检查表.docx

. 塑胶件 Plastic components 有无做干涉检查 ? If interference test 有无做 draft 检查 ? If draft test 有无透明件背后丝印 /喷涂要求 ?如果有 ,不能有任何特征在该面上 . If requirements of silk printing or painting in the back of the transparency components, and with no features on it. 壳体材料 , Housing material 壳体最小壁厚 , 侧面是否厚度小于 1.2mm. If the least thickness of the side wall of the housing less than 1.2mm 设计考虑的浇口位置 , 有无避位 ? If anti-interference according with the gate 熔接线位置是否会是有强度要求的地方 ? If weld line with requirements of intensity 壁厚突变 1.6 倍以上处有无逃料措施 ? If wall thickness break over 1.6 times with slope transition 壳体对主板的定位是否足够 ( 至少四点 ) If housin