喷墨部分自学-页宽产品培训更换打印头.pptxVIP

Test installation and calibrate the print bar IMPORTANT: A new duplex module must be installed before calibration/initialization. Use the following steps to test the printbar functionality: 1. Cover the ink supply sensor with the magnetic tool. 2. Turn the printer power on. 3. Touch/press the Home button. 4. Touch/press the Back button. 5. Touch/press the Home button twice to access the Engineering menu. 6. Open the following menus: ? Service menu ? Special Reports ? Print Mech Tap Tests 7. 552 and 577 models only: Perform tap tests 378, 379, and 380. Check for pigtail leaks after each test. A