仪器操作规程-12.Sonde Command Line.pdfVIP

YSI Technical Note Sonde Command line Documentation The YSI series sondes are usually accessed through the menu. However, there are commands that can be give from a command line (# prompt) or from the SDI-12 interface. Some of the basics for using these commands are shown below. 1. General Overview Commands are not case sensitive. Only spaces are recognized as delimiters. A command is terminated by CR Unless otherwise indicated all items which configure the sonde are saved to non volatile memory and will retain their values when the sonde is powered down. 2. Command List and Description Calibrate i f|”uncal” Calibrates a sensor directly from command line. i f 0 Spcond mS 1 DoSat 2 DomgL 3 Depth (current units of feet or meters) 4 2 point ph 5 3 point ph 6 1 point ph 7 Orp mV 8 Cond mS 9 Salinity ppt 10 1 point Turbidity NTU 11 2 point Turbidity NTU 12 3 point Turbidity NTU 13 1 point NH4+ mg/L 14 2 point NH4+ mg/L 15 3 point NH4+ mg/L 16 1 point NO3- mg/L 17 2 point NO3- mg/L 18 3 point NO3- mg/L 19 1 point Cl- mg/L 20 2 point Cl- mg/L 21 3 point Cl- mg/L f is the value to cal to. Optionally f may be replaced with the key word uncal. This will cause the sonde to discard its calibration and revert to the board only cal. E.g. calibrate 0 uncal will cause the sonde to set its conductivity cell constant to 5. Also note that to perform a multipoint calibration, like 3 p