设计说明书 斜盘轴向柱塞泵设计.pdfVIP

摘 要 斜盘轴向柱塞泵是液压系统中被广泛使的动力元件，用于各类工程机械 中。其本身结构的特殊性工作柱塞存在着剩余容积、缸体与柱塞加工修配等 相对困难，并且维护成本高、以及缸套加工成本高等问题。 针对上述问题进行以下几方面改进； （1）柱塞内放入填充物； （2）在 缸孔内加入内套； （3）采用带内圈轴承改善加工条件。 通过上述的措施可有效的提高斜盘轴向柱塞泵的容积效率、降低维护成 本提高了性能品质、节约缸套加工成本；在上述改进的基础上设计一款额定 压力： P  31.5MPa ；额定转速： n  1000r/min ；额定排量： Q  160 s T max ml/r 的手动伺服变量斜盘轴向柱塞泵，并进行柱塞与滑靴、缸体、斜盘、泵 轴的受力分析以及强度校核，结果满足相应的设计要求。 关键词 轴向柱塞泵 斜盘 缸体 柱塞 I Abstract Wobble-axial piston pump is dynamic components which are widely used in various construction machinery in hydraulic system. Because its own special structure 、there is a plunger residual volume 、processing and fixing of the cylinder plunger are relatively difficult, the costs of maintaining and the processing of cylinder is high To address the above issues carrying on following aspectses improvements: (1) Add cramming in plunger; (2) adding inner sleeve in the cylinder hole; (3) improve the processing conditions with bearing inner ring. Passage of these measures can effectively improve the Wobble-axial piston pump volumetric efficiency, reduce the costs of maintaining and enhanced the quality and performance, saving cylinder processing costs; In improving on the basis of the design pressure rated :P  31.5MPa ; Rated Speed : n  1000r/min ; s Rated Displacement : Q  160 ml/r manual servo variable axial piston pump T max ramp site, and with the plunger Slipper, block, catch basin, Analysis of the shaft and strength check, the re