课件-西门子（高端培训）.ppt

The programming device is connected to the CPU MPI interface (CPU 0 or CPU 1). All the information is transferred automatically to both CPUs (during RUN mode on both CPUs). If one CPU is in STOP mode, transfer the program changes to the master CPU in RUN mode (when the standby system is started (link and update), the user data in the master CPU is written to the standby CPU). If both CPUs are in STOP mode, start the CPU to which you loaded the changes first (for the same reason as above). The rules of designing and programming a standard S7-400 system also apply to the S7-400H. From the viewpoint of user program execution, the S7-400H behaves in exactly the same manner as a standard system. The integral synchronization functions of the operating system are executed automatically in the background. You do not need to configure these functions in your user program. In redundant operation, the user programs are stored and executed synchronously and event--driven on both CPUs. However, we offer you various blocks which you can use to tune your program in order to improve its response to any extension of cycle times due to operations such as updates. Configuring Hardware The simplest way of achieving a redundant hardware configuration consists in initially equipping one rack with all the redundant components, assigning parameters to them and then copying them. You can then specify the various addresses (for one-sided I/O only!) and arrange other, non-redundant modules in individual racks. Special features in presenting the hardware configuration In order to enable its quick recognition of a redundant DP master system, it is represented by two closely parallel DP cables. Assigning parameters to modules in a redundant station Assigning parameters to modules in a redundant station is no different to assigning parameters to modules in S7-400 standard stations. You can select the PROFIBUS DP modules from the hardware list. For the S7-400H system, you require the IM 153