04应用通信系统综合设计2019秋ns相关新手学习篇ns2.pptxVIP

NS2 tutorial;Agenda;NS2 setup ---常見的問題;nsBench;802.11 (DCF);802.11e (EDCF);# globals and flags set ns [new Simulator] #number of nodes set num_wired_nodes 1 set num_mobile_nodes 1 set num_bs_nodes 1 ;# number of base stations set num_nodes [expr $num_wired_nodes + $num_mobile_nodes + $num_bs_nodes] set bs_id $num_wired_nodes # Parameter for wireless nodes set opt(chan) Channel/WirelessChannel ;# channel type set opt(prop) Propagation/TwoRayGround ;# radio-propagation model set opt(netif) Phy/WirelessPhy ;# network interface type set opt(mac) Mac/802_11e ;# MAC type set opt(ifq) Queue/DTail/PriQ ;# interface queue type set opt(ifqlen) 50 set opt(ll) LL ;# link layer type set opt(ant) Antenna/OmniAntenna ;# antenna model set opt(ifqlen) 50 ;# max packet in ifq set opt(adhocRouting) NOAH ;# routing protocol set opt(x) 670 ;# X dimension of the topography set opt(y) 670 ;# Y dimension of the topography #smallko add the following two lines Mac/802_11e set dataRate_ 1Mb Mac/802_11e set basicRate_ 1Mb ;#set up for hierarchical routing #(needed for routing over a basestation) $ns node-config -addressType hierarchical AddrParams set domain_num_ 2 ;# domain number lappend cluster_num 1 1 ;# cluster number for each domain AddrParams set cluster_num_ $cluster_num lappend eilastlevel $num_wired_nodes [expr $num_mobile_nodes + $num_bs_nodes] ;# number of nodes for each cluster AddrParams set nodes_num_ $eilastlevel #Open the nam trace file set nf [open out.nam w] $ns namtrace-all-wireless $nf $opt(x) $opt(y) set ntr [open out.tr w] $ns trace-all $ntr set chan [new $opt(chan)] set topo [new Topography] $topo load_flatgrid $opt(x) $opt(y) # Create God create-god [expr $num_mobile_nodes + $num_bs_nodes] # creating wired nodes for {set i