Isilon Node Firmware Package 节点固件包 10.3.5 发布说明（英文）.pdfVIP

Isilon Node Firmware Package 10.3.5 Release notes February 2021 The 10.x.x firmware provides support with OneFS 8.2.x and earlier on Generation 5 and 6 nodes. For PowerScale F200, and F600 node support on OneFS and later, install NFP 11.x. This firmware package is available for download from Dell EMC Product Support. The firmware package has been released independent of any OneFS release. Installing a firmware package will extract the files in the package archive on each node in a cluster, but will not automatically update firmware on the cluster. Follow the provided instructions to install and update the firmware on your cluster. Only one firmware package may be installed at any given time. NOTE: Its a good idea to open an SR with Isilon Technical Support to let them know you are going to perform a node firmware update. An open SR will help reduce the response time if you require assistance. • Supported platforms2 • Confirming free space2 • New features and resolved issues 2 • Known issues 3 • Firmware versions 3 • Upgrade considerations 7 • Check the firmware update progress8 • Install the firmware package and update firmware 8 • Verify the firmware installation9 • Troubleshooting 10 • Where to go for support11 Supported platforms Before you update a firmware package, contact Isilon Technical Support and confirm that your platform supports the new firmware. CAUTION: Only update firmware with this package if your cluster contains Generation 6 or Generation 5 hardware. If your cluster does not contain Generation 6 or Generation 5 hardware, update your firmware with the 9.3.5 Node Firmware Package. CAUTION: Before the node firmware update on F800, F810, H600, or H500 nodes, address a known issue by doing one of the following. Depending on the version of OneFS: ● Install a patch. ● Run a command. See the F800, F810, H600, and H