锅炉吊装工艺.docVIP

沙钢 ANANGEL SHAGANG 工程编号: 201802110 锅炉吊装工艺 SHG201802110-401GY 标记 MARK 数量 Q.TY 修改单号CORRECTED SHEET NO. 签字 SIGN 日期 DATE 版号REV. No. 质量MASS(kg) 比例SCALE 旧底图登记号 编制 DESIGNED 校对 CHECKED 0 底图登记号 审核 REVIEWED 共 7页 TOTAL SHEETS 第 1 页 SHEET No. 标检 STANDARDIZED 生产设计PRODUCTION DESIGN 山海关船舶重工有限责任公司 工 艺 所 SHG TECHNICAN DESIGN DIVISION 审定 APPROVED 锅炉吊装工艺 SHG201802110-401GY 第2页 1.锅炉相关参数 Date of the new boiler 1.1锅炉总重约：6.39t The weight of the boiler is 6.39 ton. 1.2锅炉尺寸如下图所示： The boiler size as shown in the figure below 1.2门机最大起升重量为50T，吊重曲线如下图所示； The maximum lifting weight of the door crane is 50T, and the lifting weight curve is shown as the figure below. 2吊装前的准备： Preparation before hoisting 2.1 准备好吊装所需的钢丝绳、卸扣等。所有的吊索具都需要具有证书，使用前应逐件进行仔细检查，不允许使用任何有损伤的工具、索具，决不可超负荷作业，以确保安全。 Prepare wire rope and shackle. All rigging should have a certificate and should be carefully checked before use. Any damaged tools and rigging should not be used. 2.2吊装前提前设置好警戒区域，并拉好警戒带，并用明显标志防止无关人员、车辆误入。指定专门人员进行现场监护。 Before hoisting, the warning area should be set up and the warning belt should be pulled, and obvious signs should be used to prevent people and vehicles from straying into the area. Assign special personnel for on-site monitoring. 2.3准备好用于控制锅炉的风绳30m*2条，系与螺母底部吊耳处，以控制锅炉的位置与方向 Prepare 30m*2 wind ropes for controlling the boiler and tie them to the lifting lug at the bottom of the nut to control the position and direction of the boiler. 3锅炉的吊装 The new boiler hoisting 3.1 吊装锅炉开工艺孔，工艺孔位置如下图所示的方框位置: Hoisting boiler opens the process hole, and the position of the process hole is as follows: 锅炉吊装工艺 SHG201802110-401GY 第3页 3.2 用门机将锅炉平稳缓慢地吊至指定位置，即锅炉进机舱的工艺孔甲板位置，放置平稳。锅炉吊装如图所示： Lifting the boiler to the designated position steadily and slowly, i.e., the position of the technical hole deck where the boiler enters the engine room smoothly. The hoisting of the boiler is show