北京现代朗动资料：MDc_TPMS_final.pptVIP

Material: Slide Trainees textbook Rim WE sensor Method: Lecture, Practice Sensor Mounting (2/2) Steps 4, 5. When the valve is completed inserted, fasten the nut with your hand while the sensor contacts the rim. Step 6. Use a screwdriver to finish installation while keeping the valve and sensor from moving. Understanding the method for sensor mounting. SS * * GDS in TPMS - Sensor Status Service procedure Sensor Status By using Exciter, you can check sensor status. Perform the following procedure as below. Position the GDS TPMS as near as possible to the tire. Press the GDS TPMS module’s retry button that you want to know. Check sensor status in table. SS * Material: Trainees textbook Training vehicle TPMS exciter, GDS Method: Lecture, Practice Lead over: Let’s have a look at the Service procedure in GDS. To understand the service procedure corresponding to sensor status. * Material: Slide Trainees textbook Rim WE sensor Method: Lecture, Practice Lead over: This is the method for mounting sensor. Sensor Mounting (1/2) Keep in mind that the valve (silver air intake) may shift from its original position during WE sensor transportation. Rules to note: The valve must be in its original location (metal bracket). Step 1. Hold the WE sensor as shown in the figure. Step 2. Place the valve through the valve hole until the seal washer (black doughnut-shaped seal) contacts the rim. Step 3. As shown in the figure, hold the housing with two fingers and use another finger to guide the valve into the valve shaft. Then ensure that the housing laser mark is visible. Caution: If you push the front of the housing in the direction of the rim, the valve will fall out. Understanding the method for sensor mounting. SS * Material: Slide Trainees textbook Rim WE sensor Method: Lecture, Practice Lead over: This is the method for mounting sensor. Sensor Mounting (2/2) Steps 4, 5. When the valve is completed inse