灯具产品EMC认证知识介绍.pptxVIP

灯具产品EMC认证知识介绍 Prepared by: Louisa Lu Aug. 26, 2011 灯类产品EMC认证 目 录 欧盟CE认证 美国FCC认证 中国CCC/CQC认证 灯类产品EMC认证 PART 1 : CE EMC认证 灯类产品EMC认证 CE EMC测试标准： EN55015 (Emission) EN61547 (Immunity) 如产品为AC供电，还应增加以下标准： EN61000-3-2 (Current Harmonic) EN61000-3-3 (Voltage Flicker) 灯类产品EMC认证 EN55015测试项目： (1) Disturbance Voltage (2) Radiated Disturbance (9kHz to30MHz) (3) Radiated Disturbance (30MHz to 300MHz) (1) (2) (3) 灯类产品EMC认证 EN55015 Disturbance voltage 测试项目限值： 灯类产品EMC认证 EN55015 Radiated Disturbance (9kHz to30MHz) 测试项目限值： 灯类产品EMC认证 EN55015 Radiated Disturbance (30MHz to 300MHz) 测试项目限值： 灯类产品EMC认证 EN61547测试项目： Electrostatic Discharge静电放电 (IEC 61000-4-2) Radio frequency electromagnetic fields 辐射抗扰度 (IEC 61000-4-3) Fast transients 快速瞬变脉冲群 (IEC 61000-4-4) Surges雷击、浪涌 (IEC 61000-4-5) Injected currents 传导抗扰度 (IEC 61000-4-6) Power frequency magnetic fields工频磁场 (IEC 61000-4-8) Voltage dips and interruptions电压跌落/电压中断 (IEC 61000-4-11) 灯类产品EMC认证 Performance criteria Performance criterion A: During the test no change of the luminous intensity shall be observed and the regulating control, if any, shall operate during the test as intended. Performance criterion B: During the test the luminous intensity may change to any value. After the test the luminous intensity shall be restored to its initial value within 1 min. Regulating controls need not function during the test, but after the test the mode of the control shall be the same as before the test provided that during the test no mode changing commands were given. Performance criterion C: During and after the test any change of the luminous intensity is allowed and the lamp(s) may be extinguished. After the test, within 30 min, all functions shall return to normal if necessary by temporary interruption of the mains supply and/or operating the regulating control. Additional requirement for lighting equipment incorporating a starting device: After the test the lighting equipment is switched of