UG刚柔耦合仿真分析.pdf

1.In this lesson After completing this lesson, you will be able to: Create an SEMODES 103 – Flexible Body solution in Advanced Simulation. Connect the flexible body finite element model to the degrees of freedom in the motion mechanism. Solve the finite element model and generate the RecurDyn Rflex input file. Define the flexible body in Motion Simulation and solve the motion mechanism. Animate the motion mechanism and observe the flexible body deformation. ? ? 2. Overview Typical motion simulations represent mechanisms using rigid bodies that move in prescribed degrees of freedom according to constraints. These rigid-body motion simulations cannot represent certain dynamic characteristics, especially those resulting from conditions such as sharp impacts, sudden changes in motion, or when the component is flexible enough to affect the motion of the mechanism. For these situations, you can use a flexible body analysis to combine both elastic deformation and rigid body motion. This type of analysis requires NX Motion Simulation with the RecurDyn solver and NX Advanced Simulation with the NX Nastran solver . To set up a flexible body analysis for a component in your mechanism, you create a finite element model on the component and define stiffness at the points where it is connected to the mechanism (typically at joint locations). The NX Nastran SEMODES 103 – Flexible Body solution reduces the dynamic behavior of the flexible body to a set of mode shapes, which are stored in an output file. After you solve this modal solution, you associate the flexible body output file (.rfi file) with the link on which the component is defined in the motion simulation. When you solve the motion simulation, the RecurDyn solver communicates with NX Nastran and recov