一次性口罩成品检验报告.docxVIP

一次性口罩成品检验报告 Test report of disposable face masks 报告日期：2021 年 5 月 25 日 Report Date:2020.05.25 检验依据：检验依据：GB T32610-2016《日常防护型口罩技术规范》 Test basis: GB T32610-2016 Technical specification for daily protective masks 规格：17.5cm×9.5cm 生产数量： 抽检数量： 生产批号: 订单号： Size: 17.5cm×9.5cm Quantity: Amount Tested: LOT ： Order#： 检验项目Test Item 条款Terms 性能指标Standard Requirements 检验结果Test Result 结论Conclusion 基础要求 Basic requirements 1.1 口罩应能安全牢固地护住口、鼻。 The mask should be able to protect the mouth and nose safely and firmly. 符合Pass 合格Qualified 1.2 口罩原材料不应使用再生料，无异味。 The raw materials of the masks should not use recycled materials and have no peculiar smell. 符合Pass 合格Qualified 1.3 口罩不应存在可触及的锐利角和锐利边缘，不对佩戴者构成伤害。There should be no sharp angles and sharp edges that can be touched by the mask, which should not cause harm to the wearer. 符合Pass 合格Qualified 1.4 口罩应便于佩戴和摘除，在佩戴过程中无明显的压迫感或压痛现象， 对头部活动影响较小。 The mask should be easy to put on and take off. There is no obvious feeling of pressure or tenderness during wearing, which has little effect on head movement. 符合Pass 合格Qualified 外观Appearance 2.1 口罩表面不应有破损、油污斑渍\变形及其他明显的缺陷。 The surface of the mask should not be damaged, stained, deformed and other obvious defects. 符合Pass 合格Qualified 规格尺寸 Size 3.1 尺寸 17.5×9.5cm 注：尺寸允许误差±0.5cm。 Size:17.5cm×9.5cm Note:Tolerance ±0.5cm 17.5×9.5 合格Qualified 鼻夹Nose clip 4.1 口罩上应配有鼻夹，鼻夹长度应不小于 8cm。 The nose mask should be equipped with a nose clip, the length of the nose clip should not be less than 8cm. 9CM 合格Qualified 口罩带Mask strap 5.1 每根口罩带与口罩体连接点处的断裂强力应不小于 10N。 The breaking strength at the connection point between each mask strap and mask should not be less than 10N. ＞10N 合格Qualified 微生物清洁度(cfu/g) Microbial cleanliness 6.1 ≤30 11 TYPE II 压力差 (pa/cm2) Differential pressure 7.1 ＜40 25 TYPE II 抗溅压力 (kPa)Splash resistance pressure 8.1 ≧16.0 ≧16.0 TYPE II 细菌过滤（BFE）%Bacterial filtration efficiency(BFE) 9.1 ≥98% 98.24 TYPE II 备注 Remarks 11.1 附照片，附件一。 Attached photo in Annex 检验结论Test conclusion ： 经检验的产品样本各项指标均 GB T32610-20