ABB-FPD150 FPD160差压流量计元件孔板产品选型详细技术参数样本资料.pdf

Data sheet DS/FPD150/160–EN FPD150/160 Differential pressure – primary flow element orifice plates and orifice flange unions Simple flow metering solutions for liquids, gases and steam, backed up by comprehensive documentation, certification and testing Measurement made easy Simple orifice plate for low-cost measurement — installs direct between flanges Engineered and manufactured to latest standards — to ISO5167:2003 as standard — other design standards available Orifice flange Unions ready for direct welding into pipeline — manufactured in accordance with ASME B16.36 — tappings accurately positioned — complete with gaskets, nuts and bolts Range of flange drillings / ratings available — raised, flat or RTJ-profile FPD150/160 Differential pressure – primary flow element orifice plates and orifice flange unions Orifice plates Orifice plate types The differential pressure generated is sensed at a pair (or Concentric square edge type plate multiple pairs) of tapping points, each pair comprising a high These plates are used to measure the flowrate of clean, pressure (inlet or upstream) and a low pressure (outlet or low-viscosity liquids, gases and dry steam at Reynolds downstream) tapping. A variety of configurations are specified Numbers in the turbulent flow regime. The bore is within ISO5167 and other standards, including the following: sharp-edged on the inlet and usually parallel on the outlet, although, depending on the d/D ratio (Beta) and thickness, the D and D/2 taps outlet may be chamfered. The bore is calculated to produce — the tappings are generally located in the pipe wall the requested differential pressure at the design meter — t