RS Components 电工电料 电动机配件 EM-236 使用说明.pdfVIP

Rev.1.1 EM-236A INTERFACE UNIT FEATURES * Accurate and easy adjustment * Good adjustment repeatability * Saves space in products * Gives economical advance * Enables dynamic monitoring * Easy to use * Smaller and lighter than EM-236 * Replaces previous EM-236 EM-236A Interface unit is made for adjusting and copying adjustments of Electromen driver devices and for monitoring dynamic values during drive. EM-236A enables the searching of the right settings and adjustments for the application, and after that these settings can be reliably loaded to other units. EM-236A is handy in instrumentation and also a simple tool in production. The use in short: After the driver unit is powered the cable from EM-236A with red Micro Match connector is connected to the driver unit, (Notice the hole in board for polarity tab). The display of interface unit wakes up and after some announcements it is ready to load up parameters from the target driver (LoadEdit), if there is need to edit, the values can be changed with + and - buttons. Then the parameters can be saved with 2 seconds push of the 2sec. save button. If the operation of the driver is OK. the red connector can be connected to the next driver and with a push of Copy to device button the same parameters are loaded to the next unit and to as many units as the user desires. TECHNICAL DATA: Supply: 3-6V / 30mA Baud rate: 9600b/s ±10% Display: 2x16digits, LCD