Dell戴尔Dell Chassis Management Controller Version 4.1 Chassis Management Controller Version 4.1 Release说明书用户手册.pdf

Chassis Management Controller Version 4.1 Release Notes What’s New This release of CMC supports the following features:  Broadcom 5719 Quad Port 1GB Blade Mezzanine Card.  Expanded the CMC MIB to contain OIDs for a maximum of 32 servers in the chassis.  Expanded the CMC MIB to contain OIDs for each servers Chassis Slot number, for all servers present in the chassis.  Expanded the CMC MIB to contain an OID for the iKVM Version number, if iKVM is present in the chassis.  Support for iDRAC7 PowerEdge M420 server. Prerequisites Supported System CMC version 4.1 is supported on the following Dell PowerEdge(TM) systems in the Dell PowerEdge M1000e system enclosure:  Dell PowerEdge M420  Dell PowerEdge M520  Dell PowerEdge M600  Dell PowerEdge M605  Dell PowerEdge M610  Dell PowerEdge M610X  Dell PowerEdge M620  Dell PowerEdge M710  Dell PowerEdge M710HD  Dell PowerEdge M805  Dell PowerEdge M905  Dell PowerEdge M910  Dell PowerEdge M915 Recommended Module Firmware Versions The following chassis module firmware versions are recommended additionally if CMC version 4.1 is installed:  iDRAC Firmware Version: - 3.35 for Dell PowerEdge M610, M610X, M710, M710HD, M910, M915 - 1.60 for Dell PowerEdge M600, M605, M805, M905  iDRAC7 Firmware Version: - 1.00 for Dell PowerEdge M620 - 1.10.10 for Dell PowerEdge M420  Dell Lifecycle Controller Version: - 1.5 for Dell PowerEdge M610, M610X, M710, M710HD, M910, M915 - 2.0 for Dell PowerEdge M620, M420, M520  BIOS Version: - 1.0.0 for Dell PowerEdge M620, M420 - 6.1.0 for Dell PowerEdge M610, M610X, M710 - 5.0.1 for Dell PowerEdge M710HD - 2.7.0 for Dell P