电气预埋规范.docVIP

电气预埋规范 directly, a available steel bar will be made into a ring hook, and then cutting 20 ~ 30 mm one end fasten to conduit another one stable point or iron wire colligation fixed spacing: φ15mm ~ 20mm is 1.0 ~ 1.0 m, from 25mm to 32mm is 1.5 ~ 1.5 meters, 40mm ~ 50mm is 2.0 ~ 2.5 meters, exceed 65mm not more than 3 meters 10．电缆管与接线盒的连接可采用焊接和丝扣连接，：电缆管伸入接线盒3~6mm 管口用黑胶布包扎结实，接线盒内用湿棉纱、破布填实；外部用黑胶布缠绕，以防止水泥沙浆进入。 Welding and threaded can be used for the connection between electrical conduit and sockets, electrical conduit are putted into the sockets 3 ~ 6 mmThe mouse of the conduit with black adhesive bandage, internal parts of the socket filled with a wet cotton yarn ,cloth; External with black tape winding, in order to prevent cement mortar having a access into. 11．接线盒安装时必须与模板紧贴，并用钢筋在接线盒四周加固；电缆管直径≤DN25的指明及消防报警预埋管放置于模板与钢筋网之间，预埋管绑扎在钢筋网上，与模板之间预留间隙≥15mm；电缆管在接线盒处的固定点与接线盒间距不得大于200mm。 Socket must be clingy to the template and reinforced around, between the electrical conduit and template reserved clearance 15 mm or more. into the sockets of the cable must be welding with a cross bar (from 6 or 8mm round steel; 12. 所有外露预留的电缆管及伸入分电箱、木制接线盒等管口应伸出砼面200mm以上，电缆管口必须封堵。续接管路用胶布封口后加套帽。 All the reserved outside electrical conduit and those into the distribution box, and wooden box should stretch out the concrete over 200mm, adding iron plate welding seal, steel plate with cutting machine and smooth. The continued jacketed pipe set a cover after sealing with tape. 13．电缆管过缝制作：采用在电缆管外套比电缆管外径大两级套管，套管与电缆管口部密实封堵，电缆管套管制作规格，长度如下： Manufacture for expansion joint, adopting the two levels of casing pipe coat than electrical conduit diameter, first winding linen between casing and electrical conduit then filling with asphalt close-grained, Specifications, the length is as follows: 电缆管型号 Type 壁厚（mm） thickness 电缆管外径（mm）out diameter 过缝套管规格 specification 过缝套管内径（mm） Inner diameter 过缝套管的长度（mm）length φ25 3.25 33．5 φ40 41 600 φ32 3.25 42．3 φ50 53 800 φ50 3.5 60 φ80 80.5 1200 φ80 4 88．5 φ125 131 1800 14．