jlink使用方法笔记.docxVIP

jlink 使用方法笔记 这段时间在用 jlink 调试 freescale 的 mx51 板子，下面将使用 jlink 的方法在此做一个笔记。jlink 是segger 公司的产品，由于正版的工具巨贵，所以现在大部分人都喜欢用山寨版的jlink， 幸运的是我的山寨版 jlink 支持 arm cortex a8，所以能调试 mx51 板子。 jlink 的官方提供调试软件和驱动，调试软件有 jlink commander（j-tag 调试）、j-mem（内存查看）、j-flash（flash 烧写）等。我主要用到的是 jlink commander，以下是它的命令集： SEGGER J-Link Commander V4.20h (? for help) Compiled Oct 5 2010 19:11:57 DLL version V4.20h, compiled Oct 5 2010 19:11:41 Firmware: J-Link ARM V8 compiled Oct 5 2010 08:59:59 Hardware: V8.00 S/N:Feature(s): RDI,FlashDL,FlashBP,JFlash,GDBFull VTarget = 3.280V Info: TotalIRLen= ?, IRPrint = 0x..FFFFFFFFFFFFFFFFFFFFFFF1 WARNING: CPU core not found. No devices found on JTAG chain. Trying to find device on SWD. WARNING: CPU core not found. ****** Error: Parity error (Data = 0xFFFFFFFF, ReceivedParity = 1) No device found on SWD. Did not find any core. Info: TotalIRLen = 9, IRPrint = 0x0011 Found 2 JTAG devices, Total IRLen = 5: #0 Id: 0x2B900F0F, IRLen: 04, IRPrint: 0x0, ARM ETB #1 Id: 0x07B76F0F, IRLen: 05, IRPrint: 0x1, ARM1176 Core ARM11 identified. J-Link Available commands are: f Firmware info h halt g go Sleep Waits the given time (in milliseconds). Syntax: Sleep delay s Single step the target chip st Show hardware status hwinfo Show hardware info mem Read memory. Syntax: mem Addr, NumBytes (hex) mem8 Read 8-bit items. Syntax: mem8 Addr, NumBytes (hex) mem16 Read 16-bit items. Syntax: mem16 Addr, NumItems (hex) mem32 Read 32-bit items. Syntax: mem32 Addr, NumItems (hex) w1 Write 8-bit items. Syntax: w1 Addr, Data (hex) w2 Write 16-bit items. Syntax: w2 Addr, Data (hex) w4 Write 32-bit items. Syntax: w4 Addr, Data (hex) wm Write test words. Syntax: wmNumWords is Identify length of scan chain select register ms Measure length of scan chain. Syntax: msScan chain mr Measure RTCK react time. Syntax: mr q Quit qc Close JLink connection and quit r Reset target (RESET) rx Reset target (RESET). Syntax: rxDelayAfterReset RSetType Set the current reset type. Syntax: RSe