Four Function Spa Side Remote Installation Instructions说明书用户手册.PDF

Installation Instructions Four Function Spa Side Remote WARNING FOR YOUR SAFETY: This product must be installed and serviced by a professional pool/spa service technician. The procedures in this instruction sheet must be followed exactly. Turn off all power at the breaker panel before proceeding with these instructions. Failure to do so could result in an electrical hazard which could result in death or serious injury due to electrical shock, and may also cause damage to property. The Four Function Spa Side Remote is a double 4. At the Power Center, feed the remote cable into insulated, submersible device which is ETL listed (to the low voltage compartment (left-hand side). Strip UL Standard 1563) for installation at the waters edge. the cable jacket 4 and strip each wire ¼. Use the It is typically installed at the tile-line of the spa wall, or P.C. Board Wiring Diagram on the inside of the in the deck within arms reach of the spa. It can be Power Center door to locate the Four Function used with a gunite spa, acrylic spa, or hot-tub. Remote terminals. Wire the remote according to When installing the Four Function Remote, it is the diagram. important to make provisions for this hard-wired 5. At the Remote mounting location, press (do not remote before the pool/spa construction is com- screw) the Four Function Remote into the PVC plete by running electrical conduit from the desired pipe. remote location to the future Power Center location. Do not instal