超临界CO2离心压缩机的干气密封设计.pdfVIP

Dry Gas Seals Design for Centrifugal Compressors in Supercritical CO2 Application • Rafael Kassimi - Detlev Steinmann - Jonathan Kleiner - Paolo Susini • Alberto Milani - Matteo Dozzini 1 The 7th International Supercritical CO2 Power Cycles ● February 21 – 24, 2022 ● San Antonio, TX, USA 1 DGS Requirements for sCO2 Centrifugal Compressor DGS design parameter •CO2 as sealgas, in supercritical condition •Tandem seal configuration | Bi-directional •Lowest leakage •Shaft size: Ø 75mm •Pressure: static/dyn. 285/200 barg (3.625/1.885 psig) •Temperature: -46 to 250°C (480 °F) sCO2 seal Design •Speed: 205 m/s @ OD (656 fps) èTo simulate the side conditions and match the sCO2 Seal Oper. simultaneous combination of all above mentioned requirements an extensive test campaign was performed. 2 The 7th International Supercritical CO2 Power Cycles ● February 21 – 24, 2022 ● San Antonio, TX, USA 2 Dry Gas Seal for sCO2 – Design Challenges • FLS BH collaboration • To predict the interaction between the seal and the compressor an iterative exchange of analysis was done. • Compressor design analysis • temperature profile @ seal cavity, including heat gen