- 97
- 0
- 约2.51万字
- 约 35页
- 2022-08-27 发布于天津
- 举报
便捷式自动晾衣架设计
摘要 :传统的晾衣架就是一固定的晾衣杆,挂取衣物非常麻烦吃力,现今,家用的
晾衣架越来越趋于自动化,出现了手摇式晾衣架和电动式晾衣架,其中,电动晾衣
架因具有占用空间小、操作省力、使用便捷等优点,受到越来越多家庭的青睐。电
动晾衣架包括有晾衣杆、晾衣杆两端的绳索和用以控制绳索绕卷的控制装置,其
中,为防止输超出移位,两端一般都放置行程开关,电机带动丝杠转动,晾衣杆就
自动的前进、后退:智能晾衣架的机械部分是在普通拉杆式晾衣架两支撑杆的端部
各安装一个滑轮。滑动杆与最前外面的晾衣杆固定连接。滑动杆的另一端连接到与
直流电动机相连的转轴上,通过电动机的正反转达到晾衣架的伸缩效果。其控制部
分的电路 CPU 采用 89C2051 单片机。利用温度、雨水、光敏等传感器,达到下雨时
自动收回,雨后自动伸展;气温高于设定值时自动收回,低于设定值时自动伸展;
夜晚自动收回,白天自动伸展的功能。
关键词:智能衣架,单片机
Design of Portable automatic clothes hanger
Abstract :Traditional dryer is a fixed airing, hanging clothes very difficult trouble, today,
the home of the dryer is more and more tend to automation, a wind-up dryer and electric
type dryer, the electric dryer because of has a small footprint, easy operation, the
advantages of convenient use, favored by more and more families. Electric dryer consists of
airing, airing on both ends of the rope and a rope around the volume control device to
control, among them, in order to prevent lost out of shift, both ends are generally placed
travel switch, the motor drive screw rotation, automatically put forward and backward:
intelligent clothes-horse mechanical part is in ordinary lever type dryer two end of support
bar on each install a pulley. Sliding rod and the top outside the airing of fixed connection.
On the other side of the sliding rod connected to the connected to the dc motor shaft, motor
through positive and negative to convey to the scale effect of dryer. The control part of the
circuit USES the 89 c2051 single chip microcomputer CPU. Using, such as temperature,
rain, photosensitive sensor to automatically when it rains, the rain automatic tension; The
temperature is higher than the set value automatically withdraw, below the set value
automatically extend; Night back automatically, automatic stretch during the day.
Keywords :intelligent hangers, chip microcom
您可能关注的文档
- 设计说明书-1.4L排量4×2型轿车5档手动变速器设计.pdf
- 设计说明书-2.54L排量4X2轻型卡车5档手动变速器设计.pdf
- 设计说明书-20T吊钩桥式起重机设计.pdf
- 设计说明书-20钢圆柱体油淬过程温度场模拟.pdf
- 设计说明书-45钢热处理加热过程对组织和性能的影响.pdf
- 设计说明书-45钢热处理空冷过程分析.pdf
- 设计说明书-45钢热处理水冷过程分析.pdf
- 设计说明书-45钢热处理油冷过程分析.pdf
- 设计说明书-60钢基体表面熔渗高熵合金工艺及性能研究.pdf
- 设计说明书-125cc摩托车风冷发动机的曲柄连杆机构设计.pdf
- 2026年环保新材料行业应用创新报告.docx
- 信息安全工程师考试试卷(2篇)2025年专项训练.docx
- 2025年《Unity3D交互设计》专项训练工程师项目评估卷.docx
- 2025年教师资格证《职业道德与法规》真题汇编.docx
- 20226年春江苏开放大学环境法规与标准060118过程性考核作业三.pdf
- 2026年春江苏开放大学清洁生产审核060497平时作业1-3.docx
- 2026年春江苏开放大学环境法规与标准060118过程性考核作业一.docx
- 20226年春江苏开放大学环境法规与标准060118过程性考核作业四.doc
- 2026年春江苏开放大学现代城市社区建设概论050016大作业答案.docx
- 2026年春江苏开放大学环境法规与标准060118过程性考核作业一.pdf
原创力文档

文档评论(0)