EMERSON艾默生 Manual GENERAL OPERATING MAINTENANCE INSTRUCTIONS FOR -12 TRIM SERIES ACTUATORS Bettis说明书用户手册.pdf

GH BETTIS GENERAL OPERATING MAINTENANCE INSTRUCTIONS FOR -12 TRIM SERIES ACTUATORS PART NUMBER 71584 REVISION A DATE: JULY 1987 ECN DATE REV LTR By * Date A9280 07/15/87 A Compiled BSC 07-16-87 Checked BC 07-20-87 Approved RTU 08-07-87 Approved AJP 08-07-87 * Signatures on file Bettis, Waller, Texas GH Bettis P/N 71584 Page 1 of 3 1.0 GENERAL GH Bettis rotary actuators are designed for use with rotary valves of a broad range of sizes and types, and are applicable over a wide range of pressures, temperatures and environments. 2.0 STORAGE For applications where the actuator is not put into immediate service it is recommended that the actuator be cycled by clean dry air or nitrogen pressure at least once per month. Indoor storage, if available, is recommended for all actuators. Care should be taken to plug the cylinder ports, control valves ports and body parts to keep out foreign particles and moisture. Also, actuators should not be stored in an atmosphere harmful to resilient seals. For extended storage, contact factory. 3.0 INSTALLATION 3.1 Since there are many valves and actuator combinations, it is not