玉柴K系列维修专用工具使用说明一.pptxVIP

会计学1玉柴K系列维修专用工具使用说明一 1、缸套拨出器Cylinder liner puller(TZ100702) （6K12发动机）6K系列柴油机采用干式薄壁缸套。当缸套过度磨损或拉缸时，则需对缸套进行更换。将两个支杆旋入缸体上两个对称的缸盖主螺栓孔中。将拉盘倾斜穿过缸孔，再将拉盘摆正，其台阶刚好卡在缸套下沿。将薄拉板与平面轴承安装在长螺杆上，并拧紧螺母及安装螺母总成。旋转螺母总成即可顺利地将缸套拨出。6K series diesel engine with dry thin wall cylinder. When the cylinder liner wear or scratch, it is needed to replace the cylinder liner. The two supporting rod is screwed into the cylinder head main bolt holes two symmetry. Pull the disc obliquely through the cylinder hole, and then pull the disc to straighten out, the bench just caught in the cylinder along. The thin plate and the plane bearing is installed in the long screw, and tighten the nuts and nut assembly. Swivel nut assembly can smoothly move the cylinder dial out.第1页/共11页 1、缸套拨出器Cylinder liner puller(TZ100702) （6K12发动机）工具组成:tool:TZ100702-2 气缸套拉拔拉盘 Cylinder drawing plateTZ100702-1 气缸套拉拔支杆及螺母合件 Cylinder rod and nut assembly drawingMC11-01-1/TTTZ100102-4 气缸套拉拔长螺杆及轴承卡簧合件 Cylinder drawing long screw and the bearing circlip memberTZ800311 气缸套压装薄拉板及顶丝 Cylinder sleeve pressing thin plate and screw 第2页/共11页 2.压缸套工具Pressure cylinder tool（TZ100701） （6K12发动机）安装缸套时，需将缸套压入缸体座孔并压装到位。当缸套放入缸体座孔之后，将压板放在缸套上沿面，用扳手将支杆固定在缸体上平面，安装顶丝装置并拧紧螺母，旋紧顶丝即可将缸套压装到位。Install the cylinder, the cylinder pressure into the cylinder bore and pressing in place. When the liner into the cylinder bore, the press plate on the cylinder surface, with a wrench rod fixed plane in the cylinder, the top wire device and tighten the nut, tighten the screw cylinder pressure can be installed in place.第3页/共11页 2.压缸套工具Pressure cylinder tool（TZ100701） （6K12发动机）工具组成:tool:TZ800311 气缸套压装薄拉板及顶丝 Cylinder sleeve pressing thin plate and screwTZ100701-1/T 气缸套压装薄螺母及支杆 Cylinder sleeve pressing thin nut and the supporting rodTZ100801-2 气缸套压装压板 Cylinder sleeve pressing plate