手机摄像模组测试设备调校效率的优化.PDFVIP

第 41 卷 第 3 期 光 学 仪 器 Vol. 41，No. 3 2019 年 6 月 OPTICAL INSTRUMENTS June，2019 文章编号：1005-5630(2019)03-0007-08 DOI: 10.3969/j.issn.1005-5630.2019.03.002 手机摄像模组测试设备调校效率的优化 陈余天 （同济大学 机械与能源工程学院，上海 201804 ） 摘要：随着手机拍照要求和性能的提升，相位检测自动对焦（PDAF ）类模组广受关注。由于手 动方式测试此类模组测试效率低、测量精度低、工人劳动强度大等不足，结合实际生产情 况，综合机械设计、机械理论、工程材料等相关知识，通过理论计算与实际模拟相结合的方 式，设计并制造了1 台三工位自动对焦设备，其实际生产效率能够达到210 片/h 。为了更好 地提高工作效率，进一步将三工位自动对焦测试设备改造成六工位自动对焦设备，改造后生 产效率能够达到360 片/h ，测试效率提升了70% 左右。 关键词：手机摄像模组；多工位自动对焦设备；测试；相位检测自动对焦 中图分类号：TH74 文献标志码：A Adjustment efficiency optimization for test equipment of mobile camera module CHEN Yutian （School of Mechanical and Energy Engineering, Tongji University, Shanghai 201804, China ） Abstract: With the improvement of mobile phone camera requirements and performance, phase detection autofocus (PDAF) module has gradually become the main stream of the market. At this stage, most small and medium-sized module manufacturers still use manual methods to test such modules, and the test efficiency is very low. In order to improve such drawbacks as low test efficiency, low measurement accuracy, and high labor intensity by the manual test equipment, based on the actual production situation, we comprehensively use mechanical design, mechanical theory, engineering materials, and other related knowledge to design and manufacture a three- station autofocus equipment