力士乐HNC100（2系列）常见问题.pdfVIP

FAQ (Frequently Asked Questions) Status: 2001-08-28 General questions What is the firmware ? What is a project ? Questions about the proj ect How can an older WIN-PED® project (version 4) be loaded with a later version of the program (version 5) ? Can a single-axis project run with a 2-axis HNC100® ? Can a 2-axis project run with a single-axis HNC100® ? How can I see on the PC side, which firmware version is required for a certain HNC100® without an HNC100® being connected ? How can I trigger a software reset on the HNC100® ? How can I select another firmware version for my control ? What do I have to do, if the requested firmware is not available in WIN-PED® ? How can I transfer the firmware to the HNC100® ? How can I create a backup of my project ? Questions about communication w ith the HNC100® What is the reason why the HNC100® does not respond after a changeover to ONLINE and the error messag e Timeout is output ? What can I do, if the menu item Send Firmware cannot be executed ? What can I do, if the menu item Initialize control cannot be executed ? Does WIN-PED® prevent a data exchange with the wrong control? How can I find out the address of an optional HNC100® (address switch error on the CB) ? How can I find the firmware version in an optional HNC100® ? Questions about the NC program Why can the NC program group not be opened? Why is the Online help (F1) not available for the NC commands? Why is it impossible to change my NC program? How can I take over an NC program from another project or another control? How can I have the current NC command that is being processed displayed? Questions about machine data Why are machine data not taken over by the HNC100® ? How can I see that the machine data were not taken over by the HNC100® ? How can I see that the machine data have not yet been saved? Questions about diagnosis How can I set digital inputs / outputs and flags from the PC? Why are inputs or outputs that were changed