Mold-机台-Operation-Manual-12ET-2.04原版完整文件.pdf

AUTOMATIC MOLDING SYSTEM Y1E 2120 Operation Manual Do not attempt to operate the Automatic Molding System until the information in this manual has been read and fully understood. Always keep this manual near the machine so that operators and service personnel can consult it at any time. TOWA Corporation 5, Kamichoshi-cho, Kamitoba,Minami-ku, Kyoto 601-8105 JAPAN DOC No.M-A0050140301-OP-12ET-2.04 Foreword Please accept our gratitude on the purchase of this machine. Operation procedures, safety precautions and general handling of the Automatic Molding System are explained in this manual. Although this machine is designed and manufactured with the principle of safety in mind, there remains the potential for dangerous accidents due to operational mistakes or improper daily care and maintenance.Before starting operation please read and study this operation manual carefully to ensure safe and efficient operation. The manual should be kept near the machine and be easily accessible to operators and service personnel. If this manual is missing or damaged, ask for new copies from our customer service center (please refer to “1.2 Customer Service Center”). Configuration of Manuals The following manuals are used in conjunction with the operation of this machine. - Installation Manual Procedures and safety precautions for machine storage, transport and set-up of the Automatic Molding System are explained in this manual. Persons concerned with machine storage, transport and set-up please refer to this manual. - Operation Manual Procedures and safety precautions for general operation, start-